Hello Jan According to the seller's official site (https://www.creality3dofficial.com/products/creality-cr-20-pro-3d-printer), the printer can print layer sizes between 0.1mm and 0.4mm. I also print 0.1mm regularly and it works fine. Compared to the Ender 3 Pro, the CR-20 has auto bed leveling (hard to say if this is an advantage, but you don't have to use it) and generally better hardware (PCB, extruder, tube). Here is also a discussion with more comments and opinions about CR-20 Pro vs Ender 3 Pro: https://www.reddit.com/r/ender3/comments/b4ez0k/ender_3_pro_or_cr_20_pro/ Many greetings Yanick

Hello Mercedes11. It's a bit difficult to classify what "much too far away" means. And is it really about the print bed levelling (it does it automatically) or rather about the adjustment of the distance of the nozzle to the print bed? I initially had difficulties with the adjustment of the nozzle distance to the print bed. I almost wanted to give the printer away because I was not satisfied with the results. The following forum then helped me to find the solution: https://forum.prusaprinters.org/forum/original-prusa-i3-mk3-zusammenbau-und-fehlersuche-bei-den-ersten-druckversuchen/neuen-drucker-bekommen-aber-fast-keine-gelungenen-ausdrucke/?mode=grid (sorry, a bit much to read, but worth it). Ultimately, it was a matter of finding the optimal z-offset. Before I adjusted it, it looked like this picture: https://forum.prusa3d.com/wp-content/uploads/attachments/22610-121889-img-20181226-125216.jpg . After the optimal setting, the area was nicely coherent and the print results were impressive. In principle, to find the z-offset, you have to make a one-layer print and screw the adjustment until this layer comes out well. It takes a little patience and time. But it is worth it. Good luck!

Hello, I have taken any glass plate. I have a 4mm float glass. Works much much better!

According to the information available, it is well equipped with the detector.

According to our information, yes.

Promotions at Digitec are not usually communicated in advance. Therefore, check back on Black Friday or any other day for new and current offers.