EUR206,77
Antec Geh FLUX PRO Midi Tower schwarz retail
E-ATX, mATX, ATX, ITX
Question about Antec Geh FLUX PRO Midi Tower schwarz retail
Have any of you installed an additional support or bracket for the graphics card in the Antec Flux Pro? I've seen a few posts on Reddit where people report that their graphics card sags slightly and they've retrofitted a bracket as a result. What are your experiences with this? If so, what bracket or support did you use?
I have an Aero 5070 Ti, where you can twist off the support foot so that it even gets past the bottom fans on the mainboard side, I didn't have to change anything on the case itself. The only problem I have is a certain resonance of the case at 10-40% speed of the two outer fans of the graphics card. This manifests itself in a quiet but perceptible humming noise. Fortunately, however, the card is usually idle (fans are at a standstill) or under heavy load, so you don't hear anything ^^
I have an RTX 5070 Ti.
You have to rebuild the fans and attach a plate to the place where the bracket or GPU foot sits.
The case offers enough space to install the fans in a different place - in my case, for example, they are mounted at the very bottom of the case (where the PSU and HDD are)
When in doubt, I took a lian li bracket (gb002) for my 409. It's discreet but it does the job.