Hello Mercedes11. It's a bit difficult to classify what "much too far away" means. And is it really about the print bed levelling (it does it automatically) or rather about the adjustment of the distance of the nozzle to the print bed? I initially had difficulties with the adjustment of the nozzle distance to the print bed. I almost wanted to give the printer away because I was not satisfied with the results. The following forum then helped me to find the solution: https://forum.prusaprinters.org/forum... (sorry, a bit much to read, but worth it).
Ultimately, it was a matter of finding the optimal z-offset. Before I adjusted it, it looked like this picture: https://forum.prusa3d.com/wp-content... . After the optimal setting, the area was nicely coherent and the print results were impressive. In principle, to find the z-offset, you have to make a one-layer print and screw the adjustment until this layer comes out well. It takes a little patience and time. But it is worth it. Good luck!