The Halder Series 3408 offers mallets in various sizes from D20mm to D50mm. These mallets are essentially a soft hammer without a handle, allowing you to hold the hammerhead directly in your hand. They are not only useful in situations where limited access makes using a traditional hammer impossible, but they also allow for precise control of striking force, accurate hits, and energy-efficient work. These small helpers are equipped with replaceable, quiet, highly wear-resistant, and splinter-free heads made of special nylon at both ends. The mallets are recoil-free because they are filled with steel shot. This means that upon impact of the striking surface on the workpiece, the shot filling follows with a delay. The reduced recoil optimally utilizes the striking energy, enabling joint-friendly and quiet work.

Product features:

• Recoil-free
• Both ends are fitted with replaceable heads made of highly wear-resistant and splinter-free special nylon
• Allow for gentle, quiet, and energy-saving work
• Precise dosage of striking effect
• Solution for limited accessibility
• Available in sizes D20mm to D50mm

Areas of application:

• Can also be used as a punch
• Joining of workpieces
• Housing assembly
• Assembly/repair work in the automotive/commercial vehicle sector
• Maintenance work with limited accessibility

Material:

• Inserts: nylon, white, hard, highly wear-resistant, no chipping (even at low temperatures), oil and grease resistant
• Assembly: nylon inserts are interchangeable

Application areas:

• Joining of workpieces
• Housing assembly
• Assembly/repair work in the automotive/commercial vehicle sector
• Maintenance work with limited accessibility
• For gentle installation and removal of bushings and ball bearings

Additional technical specifications:

• Weight: 340g
• Inserts: nylon, white
• Design: recoil-free
• Strike: hard.